1.36.30 released

For general 64bit Menuet questions and coding.
macgub
Posts: 11
Joined: Sat Jan 23, 2021 4:49 pm

Re: 1.36.30 released

Post by macgub » Fri Feb 12, 2021 9:04 pm

OK, finally I wrote Menue image to usb stick, and boot from USB. I tried various bootloaders and USB keys. Now Unetbotin do the job... Usb app says - usb 2.0 - fail (04); usb 1.x - fail (0.2uhci). In addition I want say my CPU is intel...

villemt
Posts: 12
Joined: Fri Jan 15, 2021 9:29 pm

Re: 1.36.30 released

Post by villemt » Sat Feb 13, 2021 8:34 pm

For usb2.0/ehci, it seems that BIOS is stll using the controller, so did you enable usb_legacy_disable at configuration? Another option is to disable usb legacy support in BIOS, but you might need ps2 keyboard to enable it back on. For usb1.x, it can not find the controller, so does the system->pciscan application find the uhci controller ?

macgub
Posts: 11
Joined: Sat Jan 23, 2021 4:49 pm

Re: 1.36.30 released

Post by macgub » Tue Feb 16, 2021 4:11 am

When I boot with usb_legacy_disable enabled Menuet not see keyboard (and mouse). When we talk about disbaling usb legacy support in BIOS - I dont see apropiate option in setup BIOS. Perhaps my BIOS dont support such posibility... For usb 1.x - PCIscan raport only two ehci controllers.

macgub
Posts: 11
Joined: Sat Jan 23, 2021 4:49 pm

Re: 1.36.30 released

Post by macgub » Sun Feb 21, 2021 10:43 am

Ville, from our short conversation I get signal to make a bootable usb key with MeOS and tips to emulate mouse via keyboard. With usb mass storage - despite our effort - no succes. Anyway thanks.
Greetings :!:

villemt
Posts: 12
Joined: Fri Jan 15, 2021 9:29 pm

Re: 1.36.30 released

Post by villemt » Tue Feb 23, 2021 5:54 pm

If motherboard has usb 3.0 (xhci) support, then it doesn't necessarily have usb 1.x controllers. All usb traffic can be handled with xhci.

macgub
Posts: 11
Joined: Sat Jan 23, 2021 4:49 pm

Re: 1.36.30 released

Post by macgub » Tue Feb 23, 2021 10:08 pm

Does MeOS have xhci support ? Maybye I should buy pci usb 3.0 extension card. Will it work? I think about pci eide extension card too. So I could plug one of my ide hdds. But is for me mystery if it will work in MeOS with one of ide canal ( for example primary master). :?:

villemt
Posts: 12
Joined: Fri Jan 15, 2021 9:29 pm

Re: 1.36.30 released

Post by villemt » Wed Feb 24, 2021 1:12 pm

Menuet does not have a usb 3.0 (xhci) support, just usb2 (ehci) and usb1 (ohci and uhci).

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest